STEP 1
After unpacking, open the door and remove the baskets.
STEP 2
Removing the Device Rack
|
Push the top edge down to release the top of the Stainless Steel Device Rack. |
Carefully tilt and lift the bottom of Stainless Steel Device Rack. Avoid scratching the cabinet base. |
STEP 3
Routing the cables
|
Open the charge compartment by sliding the lid out. NOTE: Door must be open to slide the lid out. |
Plug in the device chargers. NOTE: US power outlets pictured for illustration purposes. Country specific outlets will be sent with your product. |
|
Push the device connector through the hole and then pull along the rubber grip cable holder. |
Repeat for the remaining device chargers. |
STEP 4
Assembling your devices in the Carrier 15 Charging Station
|
Place the basket with the devices into the Carrier 15 Charging Station. |
Connect the cable to the device. |
Adjust the cable length to reach your devices. |
Loop and neaten the excess cable. |
|
Neatly bundle the excess cable in the charge compartment. The power strips can be slid along the track to create space. |
Replace the lid over the charge compartment. |
Close the door and use a padlock to secure. |
Plug the Carrier 15 Charging Station power cable into the unit, then into the wall socket. Charging will commence automatically (may need to switch the wall outlet “on”). |
STEP 5
Mounting the Carrier 15 Charging Station
When mounting
to a wall, ensure that the unit is mounted level or slightly tilted backwards to ensure
that the door does not swing open when the padlock is removed. Use washers or
other suitable spacers.
|
Note the mounting holes for wall mounting: TOP |
Note the mounting holes for wall mounting: BOTTOM |
Note the mounting holes for desk mounting: |